كل الرسائل

watageek You cannot use it to feed the motor, the purpose of a step down is to lower the input voltage to, example, 5volt to a flight controller or to feed 12 volt LED from a 4S-5S lipo. You could ( not saying you should) isolate the flight controller and use 3S on the lizard95. ESC/motor may burn.

2018-10-13 08:39:47 مساعدة (0)
عرض
أجابات (5)

سؤال: Whichwireis for what? Black is for Ground and what is with orange and grey?

السؤال بواسطة dominic.e135 على 2019-03-27 09:56:43

watageek Grey is signal and orange is 3.3v input

2019-05-21 08:47:12 مساعدة (1)
عرض
أجابات (1)

watageek Most of the time, yes on any free UART. Keep in mind there is sometime inverter transistor. Select corresponding UART in configurator for serial_RX.

2019-05-21 08:37:39 مساعدة (0)
عرض
أجابات (1)

سؤال: what is the difference between these Lite and the normal (no light) version?

السؤال بواسطة dbrum على 2017-12-06 10:01:49

watageek Lite and normal support dshot300 max Bb1 chip 6g average. Lite_S (9g) and V2 (6g) are BB2 chip support dshot600 max.

2019-04-03 07:24:52 مساعدة (1)
عرض
أجابات (2)

سؤال: Measurements? Because "suitable for 2205 motors" is like saying nothing...

السؤال بواسطة Kikerumbo على 2017-11-30 09:05:35

watageek ... but 693 should be 8mm od x 4mm thick x 3mm id. Not 8x3x3. This is not 693?

2017-12-24 06:27:53 مساعدة (0)
عرض
أجابات (3)