كل الرسائل

MoriXTV The wing is glued but the glue is very weak and doesn’t stick to the foam that hard so you can easily peel it of and glue it back in. I replaced the glue in the whole frame just to make sure it doesn’t fall apart at 220kph ;)

2019-07-30 06:28:58 مساعدة (0)
عرض
أجابات (1)

سؤال: What's the "T" pads purpose? Test something?

السؤال بواسطة marco على 2019-06-10 07:34:55

wujiahui “T” indicates that adding a normally closed temperature sensor switch can extend the temperature protection function, and the switch should remove the OR resistor next to the solder joint.

2019-06-11 08:34:26 مساعدة (0)
عرض
أجابات (1)

marco Andwhy this should be an ESC fault? It's an opto esc and it's also written in the description "BEC (Linear): NO".

the_KHA 19/09/2018
2
تعليقات (3)

سؤال: Does it work with 16 Volt 4s? I Have had one at it got broken.

السؤال بواسطة winowin على 2019-02-08 05:30:44

marco the connector is clearly for a 3S battery...

2019-02-10 11:49:47 مساعدة (0)
عرض
أجابات (1)

سؤال: What is the servo connector in the wing? Since it is so unusual, why wasn't the mate included in the kit?

السؤال بواسطة herosformula على 2017-12-14 11:45:45

marco Not in the kit, i agree that they should have at least highlighted that it will need a not-standard servo connector. Ayway, it's not an XT60 connector for sure. How did you manage to wire the servo cable? Mine came with already glued/never cut wire channel...

2019-01-28 03:25:29 مساعدة (0)
عرض
أجابات (2)