APteH
APteH Dearfriend, Perhaps You don't understand the function of the build in battery. When the clock is disconnected from external source , the timer IC will be kept running. So when the clock is connected again to the supply, you don't have to adjust time as that timer IC was keeping the time. Have fun with your clock!
سؤال: Can this converter control by Arduino? I mean program it using Arduino to control it. Thanks
السؤال بواسطة tanmg177 على 2018-12-23 02:18:45
APteH The only thing you can control, is the EN connection (chip enable) Variating ratio is only possible by changing boot capacitor or coil I do not recomment that as the 1200 Khz frequency wil give the best results. see datasheet : www.richtek.com/Products/Switching%20Regulators/DC_DC%20StepDown%20Convertor/RT8272?sc_lang=en
2019-05-20 06:53:13 مساعدة (0)سؤال: What is the EN pin on the input for?
السؤال بواسطة MartinC على 2019-04-18 01:57:42
APteH EN is chip enable. A high is Enable, low is disable
2019-05-20 06:42:31 مساعدة (2)
ندعوك بصدق للاشتراك في البريد الإلكتروني Invite Answer!
إذا قمت بالاشتراك ، فسندعوك عبر البريد الإلكتروني للإجابة على الأسئلة التي يطرحها الأشخاص حول المنتجات. باشتراكك] سوف تكسب أيضًا "شارة مفيدة "! يمكنك إلغاء الاشتراك في أي وقت على صفحة إعدادات الخصوصية.
ساعد الآخرين وكن أكثر سعادة!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
.jpg)
APteH Ajumper must fitted by hand and a zero ohm resistor is fitted via a roll o resistor and a soldermachine. That's why