كل الرسائل

BG341121491 12/06/2021
First of all: Definitively tighten the screws before the first flight! I am talking about the ones clamping the arms and frame, however the controller (has dampeners) and the plasticspacers should not be too tight. + Fast, sturdy, nimble drone, long flight time, nice analog camera image - For complete beginners the Drone may be a bit large und the arms are relatively thin - After a light crash one of the motor bells was slightly bend which led to vibrations which freaked the controller out. Whoops. These new vibrations are probably how I lost two screws from the frame. So now I ordered replacement motors. + Great small universal Remotecontrol that can also be used in a simulator and with other receiver-types + Very useable universal Goggles with Record-Function (no micro sd included, max 32GB) and even my glasses can just fit + gps-directions if you get lost + really loud beeper with backup energy source - The beeper has to be manually armed/disarmed to work + charge brick is idiot proof, eu travel adapter was included, can be used to check voltage before takeoff - charge brick only charges to 4,2V not to 4,35V what the included hv-lipos are rated for (standard lipos like the ones in the remote control are 4,2V; but these can also be charged inside remote through usb-c) - charge brick has no option for storage-charge - Mine stopped working after 6 charged batteries. So maybe use this one only as a battery-checker and get a better charger. However Banggood kindly reimbursed me some money for it (Thank you) + fancy bag with shoulder strap - after assembling the antennas the bag is too shallow for the quad to fit with the rest of the set and because of the glued antenna tubes even unscrewing is no real option Changes I did: - Enabled Gps Resque as Failsafe + put it on a switch - Put Turtle Mode on a Switch - Set Pre-Arm (after accidently launching the drone one time) - Reduced Video Transmit Power to 25mW (local Regulations...) - Tightened the screws!
6
التوصيات
تعليقات (0)