كل الرسائل

سؤال: does this remote work on any drone?

السؤال بواسطة thomasverkerk على 2020-12-21 12:08:37

KevvvLar FHSS is a Futaba radio protocol. So long as your receiver is using the FHSS then you’re fine.

2021-01-09 07:17:41 مساعدة (0)
عرض
أجابات (4)

سؤال: Is it ok for the Racerstar BR1811-2000KV engine ??

السؤال بواسطة ConteVlad على 2019-09-02 03:52:51

KevvvLar Thatall depends on what you're flying. From personal experience I wouldn't use a folding propellor on anything other than a motor glider. Looking at the stats for the motor it produces 150g of pull on a 6x3 prop. Your model would have to weigh between 215g - 250g to give a thrust ratio of 60-70% of the AUW (all up weight) - that is if you're sticking the prop on a motor glider. If it's anything other than a glider I wouldn't bother with a folding prop because the model moves too fast and the blades fold back too easily leaving you no power to pull the aircraft through the air.

2020-12-09 04:16:40 مساعدة (0)
عرض
أجابات (1)

سؤال: Can use 30A esc with this motor?

السؤال بواسطة weeliam_wong على 2019-09-16 09:56:05

KevvvLar If you look at the test data for different propellers the required ESC would vary between 20 to 40 amps. Smaller props with less voltage would require less amps.

2020-07-01 03:07:09 مساعدة (0)
عرض
أجابات (2)

سؤال: what diameter is the prop shaft?

السؤال بواسطة KevvvLar على 2020-05-08 03:09:44

Felicity not sure

2020-06-07 09:04:11 مساعدة (0)
عرض
أجابات (1)

سؤال: Does this sound system contains the engine sound of helicopter ?

السؤال بواسطة david على 2019-08-02 12:47:58

KevvvLar Not as standard but if you plug it into your computer you can download different sound files. I think on the one I ordered it had sound files for a radial engine and I downloaded the sound files for a Merlin engine found in a Spitfire. Sounds great.

2020-05-31 03:10:35 مساعدة (1)
عرض
أجابات (1)

سؤال: Already asked by another: Can the wheel be turned 90° to be able to fold flat into the wing?

السؤال بواسطة BG413254020 على 2020-05-10 06:04:21

KevvvLar Yes. Loosen the grub screw and take out the wire leg. Be sure to file or grind a flat onto the side of the leg in contact with the grub screw otherwise the leg could twist on contact with the ground. You’ll notice a flat on it already, just do the same 90 degrees to that.

2020-05-17 01:26:59 مساعدة (1)
عرض
أجابات (1)

سؤال: what size propeller does it require?

السؤال بواسطة JoseB على 2019-08-19 10:44:37

KevvvLar A 5x3 prop would do just fine

2020-03-23 06:41:53 مساعدة (1)
عرض
أجابات (2)

سؤال: are the header pins for the servos already soldered on?

السؤال بواسطة KevvvLar على 2019-09-11 12:13:48

srang Yes,on the FrSky RX6R receiver the header pins are already soldered.

2020-03-19 12:18:43 مساعدة (1)
عرض
أجابات (1)

PaoloMascagni ladifferenza sta nella possibilita di trasmettere in modo b16 per il modello internazionale. il canale b16 in gran parte di europa " inlegale"

2019-10-23 11:27:25 مساعدة (0)
عرض
أجابات (1)

GroundControlRC The Wing / Aileron Servo goes into the center of the fuselage and upside down so the servo arm is under the wing. I posted a Tutorial Series on building this Plane Step-by-Step and performed the Maiden Flight. I would provide a link to the Playlist but it 's not allowed from this post. If you go to our Youtube Channel (Search for Ground Control RC) and select the Playlist Tab you will find the Playlist for the Build Tutorial and Maiden Flight of this Plane. See you in the Air! Ground Control RC

2019-09-11 05:03:32 مساعدة (0)
عرض
أجابات (1)