كل الرسائل

peter1122 Thisis not the printer's fault. New printer, check the fep film. The screws are tightened on the bottom of the resin tank. If the film is slightly stretched or damaged - replace immediately. If the exposure time is too long or you print on too large surfaces, the film will be damaged sooner. Once during the replacement, I accidentally pressed the film with the screwdriver, no serious damage appeared, but I removed this film (trash) and replaced it again. I only use nfep (pfa) 0.15mm film, (less adhesion, longer lifespan) it has a lifespan about 10-30 prints. I started uv printing 4 years ago (I have a 6 uv printer), I once had a leak due to a damaged film, but it was my fault... ;)

BG231023242 08/12/2021
6
تعليقات (3)

سؤال: have dvb-c (cable tv) signal reception?

السؤال بواسطة peter1122 على 2021-08-21 08:35:00

The seller Hello, this product is not supported. You can search for these IDs: 1675493, 1827198, 1672620, 1757834, 1874249. All support DVB-C.

2021-08-24 08:51:46 مساعدة (0)
عرض
أجابات (1)

سؤال: How can I use this with my multimeter?

السؤال بواسطة agocs على 2021-04-27 04:41:59

peter1122 A thermocouple produces a temperature-dependent voltage as a result of Seebeck effect, and this voltage can be interpreted to measure temperature. Type K (chromel–alumel) approximately 41 µV \°C.

2021-05-03 12:10:19 مساعدة (1)
عرض
أجابات (1)