bikinidan
سؤال: which port is the DSM satellite port so you can use DSM transmitter
السؤال بواسطة BG355212483 على 2024-03-08 05:43:18
bikinidan ALL single engined planes have a small angle to the right and down set up in the motor mount. It is to compensate for the motor torque and to stop the plane climbing badly as you increase the throttle above cruising speed. Leave it alone!
2024-04-19 08:24:57 مساعدة (0)سؤال: can I connect a spektrum satellite?
السؤال بواسطة Jasper van \\\'t Hart على 2023-12-05 02:41:18
bikinidan Nope!
2024-04-19 08:21:26 مساعدة (0)سؤال: is it compatible with Futaba transmitter ?
السؤال بواسطة Thierry على 2023-12-15 02:24:30
bikinidan Nope!
2024-04-19 08:20:51 مساعدة (1)سؤال: This wouldn't be the old JJRC W-01 (with a new board and a respray job) would it? :D
السؤال بواسطة bikinidan على 2023-08-04 06:33:33
quadcopter101 It is. The only differences appear to be the new paint job, and they removed the LCD screen from the controller.
2023-08-11 05:51:27 مساعدة (1)
bikinidan Yep, I know how you feel. I would much prefer to have a chauffeur-driven Rolls to take me where I want to go but I can only afford a Toyota Corolla. However, look on the bright side, it still gets me from A to B AND I can now afford quite a few more planes, etc at the price of this. :)
bikinidan For Multi Protocol Radio users this uses the FX/9630 protocol (need latest firmware version) or use a DSM or S-bus satellite receiver. Be warned that the flight board has shown some very strange behaviour in the Crane/Hover Mode at least!
reynolds3953 Using fhss receiver I tried all channels through channel 9 on both aileron and brushless output and was unable to get an output.
2024-01-11 05:33:49 مساعدة (0)
bikinidan The CC2500 module version can ONLY be used with the Futaba S-FHSS protocol. If you want to use things like Futaba FASST etc then you will need an external module.
2024-01-03 05:23:29 مساعدة (0)سؤال: mode 1 or 2?
السؤال بواسطة ChrisP على 2023-08-06 07:30:26
bikinidan Supplied as Mode 2 but you can easily swap to Mode 1.
2024-01-03 05:19:21 مساعدة (0)
bikinidan The Firefox helicopter does NOT use the V761 protocol to the best of my knowledge and the protocol it DOES use is only supported by the full 4-in-1 module.
2024-01-03 05:15:42 مساعدة (1)
bikinidan You purchased the wrong version for the uses that you require. You should have bought the ELRS version plus a 4-in-1 module for the back OR a Jumper T-lite V2 with the full Internal 4-in-1 module.
2024-01-03 05:04:43 مساعدة (3)
bikinidan Your information is only half correct, krimdal! With the stock protocol there is NO motor failsafe when using the stock transmitter! However, if you add a satellite receiver you can set the satellite to failsafe to motor OFF in the model set-up! And a gentle rudder turn to stop the plane gliding straight away at dead stick.
2023-12-03 05:19:20 مساعدة (1)سؤال: how can it be changed to mode 1
السؤال بواسطة BG424521514 على 2023-11-28 07:35:31
bikinidan Buy it and read the manual or read through the RCGroups forums thread on this plane.
2023-11-28 08:32:00 مساعدة (0)ندعوك بصدق للاشتراك في البريد الإلكتروني Invite Answer!
إذا قمت بالاشتراك ، فسندعوك عبر البريد الإلكتروني للإجابة على الأسئلة التي يطرحها الأشخاص حول المنتجات. باشتراكك] سوف تكسب أيضًا "شارة مفيدة "! يمكنك إلغاء الاشتراك في أي وقت على صفحة إعدادات الخصوصية.
ساعد الآخرين وكن أكثر سعادة!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
bikinidan The 1.5mm port. Make sure that you use the correct DSM satellite connection cord. All the other sockets are 1.25mm and use a different wiring order.
2024-04-19 08:32:56 مساعدة (0)