BG451854250 It should work but I would check that some config files are available e if u use kipper. Or herring. I’ve never seen it but the board has two z stepper sockets.

BG451854250 It’s possible that the hand model used had a pituitary disorder and like Andre the giant had enormous hands, the size of tennis racquets. This would make everything Look tiny. There’s an old saying in the industry “ No need for photoshop if your models are deformed”. Loses a bit in translation.

BG451854250 What’s a “ninch”?

BG451854250 Non-metric? Get the f#$& outta here!

BG451854250 OD is 8mm and wall is 1.5mm thick so by some maths I get a lumen of 8-3 =5mm ID. However these products aren’t always perfect to .1 of a mm

BG451854250 I’m hoping “ABS fellatio” is an autocorrect error otherwise I am completely missing an important feature in 3D printing.

BG451854250 It has no chuck and is a small motor device so even if you fitted a drill bit would not be useable, buy a separate power drill

BG451854250 Even if you push the trigger like a feather or like a gorilla it is the same torque and speed without gears or clutch but it does the job