أجابات

Gearlos you just connect an external switch in parallel (either as a pushbutton as on-while-hold or a permanent on-off). I you dont know how to connect a switch in parallel, dont mess with it.

مساعدة (0)
عرض
أجابات (1)

Gearlos sure, the powermax is calculated as Volt x Amp, so its 220V x 10A = 2200watt. Nevertheless dont go to the limit, stay at 90% aka 2000W max.

مساعدة (1)
عرض
أجابات (3)

سؤال: I have a faulty on board sound. Can I plug into USB port and plug headphones into the 3.5mm output?

السؤال بواسطة MS971 على 2023-01-30 11:31:57

Gearlos yes, thats the purpose: an external soundcard through USB. Anyway, You should disable the defect sound in the PC BIOS. Most important is, that You configure the sound output to use the USB board (in windows in the control panel).

مساعدة (1)
عرض
أجابات (1)

Gearlos Its just a simple wiring of a HDMI cable through the box, using Ethernet wire. Reason for two CAT cables are cuz there are more wires in a HDMI. There is no electronics and *never* connet it to any Ethernet device. max, HDMI are 30 m.

مساعدة (0)
عرض
أجابات (2)

Gearlos In the start of the description, there are listed 10 specifications. Read spec. no. 8 which says the length.

مساعدة (0)
عرض
أجابات (2)

سؤال: For what is the 4 Pin X1 Connector near the USB Port?

السؤال بواسطة BG161435019 على 2021-01-27 05:38:38

Gearlos On schematics terms (the Letters used for components, like R..=resistor, T..=Transistor), X...=Clock signal. So Those are AUX clock signals. You should familiarize with some electronics standards aka read some book ;)

مساعدة (0)
عرض
أجابات (2)

سؤال: turns off about increased loads?

السؤال بواسطة BG114951163 على 2021-07-19 10:31:12

Gearlos According to manual, this inverter does only support 600W continously (the 1000Watt is short-time, like when a motor starts-up). Your device may somehow use more than 600Watt continously. Dont rely on the label says 300W, but try measure the device with a power meter and see if its over 600 Watt (allso You may measure with an AC ampere-meter. For 220V, the max. is I=P div U (ohm law) aka I = 600 div 220 = 2.7Ampere, and for 110V it is 600 div 110 = 5.6Ampere). Allso, You should be sure that the wires to the battery input is sufficient. To feed the inverter 12V at 300Watt, it is 300watt div 12V = 25Ampere, with according to the manual page 5 table is AWG 12 (or 2.5 square mm) which is like the thickness of a cigarette. If not - the inverter cannot get enough input power to source the 220V (or 110V) output. Yes Buddy, read the manual !

مساعدة (0)
عرض
أجابات (3)