سائق سيارة جميل جداً لـ بي 3 يعمل بشكل جيد جداً في الروبوتات.

Very nice Motor Driver for Pi 3. Works very good in DIY robot.

سائق سيارة جميل جداً لـ بي 3 يعمل بشكل جيد جداً في الروبوتات.

حسنا

ok

حسنا

القبعة جيدة لكن وصلات العناوين ستكون مفيدة جدا والتوثيق من الصعب جدا العثور عليها سيكون من الجيد لو كانت متضمنة

The hat is ok but address jumpers would be very useful and documentation is very hard to find it would nice if it was included

القبعة جيدة لكن وصلات العناوين ستكون مفيدة جدا والتوثيق من الصعب جدا العثور عليها سيكون من الجيد لو كانت متضمنة

These instructions are not sufficient for me to use this product

These instructions are not sufficient for me to use this product

These instructions are not sufficient for me to use this product

Using this with the Pi great for the purpose I needed it for

Using this with the Pi great for the purpose I needed it for

Using this with the Pi great for the purpose I needed it for

Exelente

Exelente

Exelente

havent used but well packed

havent used but well packed

havent used but well packed

Information on the board can be a bit hard to find, but it is out there. It is a nice board for controlling motors and servo's. This model does not have the stacking headers, so it is a bit harder to use more then one of them without either changing the hadder, or putting in jumpers for the I2C bus. The board does have solder pads to let you change the address of the board.

Information on the board can be a bit hard to find, but it is out there. It is a nice board for controlling motors and servo's. This model does not have the stacking headers, so it is a bit harder to use more then one of them without either changing the hadder, or putting in jumpers for the I2C bus. The board does have solder pads to let you change the address of the board.

Information on the board can be a bit hard to find, but it is out there. It is a nice board for controlling motors and servo's. This model does not have the stacking headers, so it is a bit harder to use more then one of them without either changing the hadder, or putting in jumpers for the I2C bus. The board does have solder pads to let you change the address of the board.

Have not tried it yet but hoping that I can find drivers for it soon.

Have not tried it yet but hoping that I can find drivers for it soon.

Have not tried it yet but hoping that I can find drivers for it soon.