لوحة توسيع محرك قناة 2 + المحرك الذكي UNO سيارة الشاسيه الروبوت ذراع 16 قناة سيرفو
تمت ترجمة جزء من المراجعة تلقائيًا.
This shield fits perfectly on my Arduino compatible board. The PWM controller is a PCA9685. This board works flawlessly with the Johnny-Five Platform, I was able to simply plug in my servos, and go. I soldered on some headers to access the pins of the Arduino which were not used by this board. You are left with 4 analog and 8 digital GPIO pins, 4 of the digital pins are PWM. All the components are on the top of the board, which made soldering the headers from the bottom very easy. I am very satisfied with this shield, and I recommend.
qualite du produit a priori au rendez vous par contre aucune notice et a ceniveau c est neecessaire
arrivato ora tuttok
Use this board to drive up to 16 servos from the I2C port of your Arduino. The 2x H bridge motor drivers are hooked up normally to PWM and digital outputs and are essentially separate from the the servo drivers section of the board. The power rails are designed to allow easy splitting for servo, motor, micro. You will need these libraries: #include #include This board uses the same chip as the Adafruit unit, they also have good tutorials and example code. Reasonable quality and good value.
l received in 18 days thank you!
nice product thank you so much. clean and speedy response
received the motor shield in one week time and is working great. excellent board, thank you very much
thank you
Good Stuff!
It was fast, and looks great, now I hjust have to try it.