كل الرسائل

Ralphbaas Seller please answer this question. It is important to know. Does the beeping stops if the voltage recovers and goes to a higher voltage than the alarm value. For example: If I go full throttle with my plane, and the alarm value is reached, the beeper will start beeping. If I then slow down with the throttle and the lipo voltage goed up (above the alarm value) will the beeping stop automatically??

2023-12-27 01:43:37 مساعدة (0)
عرض
أجابات (2)

سؤال: its dangerous in my opinion having such a big delay in the throttle.

السؤال بواسطة xboxice على 2022-08-10 06:08:25

Rhadamantis Tous les acheteurs disent qu'il y a un retard à l'accélération et à la décélération, il n'y a que le vendeur qui dise le contraire. Je pense qu'il ment, si ce sont des yunli tout le monde sait qu'ils ont un délais de latence.

2023-06-26 02:47:44 مساعدة (0)
عرض
أجابات (2)

xboxice we need a clear answer on this device people who have bought this very item? if you set it to say 3.4v to alarm and your battery SAG to this voltage then recovers back to a voltage higher than 3.4v lets say 3.7v does the alarm still beeps!!! or does it stop? beeping, and then beeps again if you go below the set 3.4v?

2022-11-28 02:32:53 مساعدة (0)
عرض
أجابات (5)

سؤال: Are part available for this model?

السؤال بواسطة xboxice على 2019-08-01 03:42:07

SteveD They say parts will be available soon, but some of these planes have been around for ages and still no parts for them, so who knows?

2019-11-11 11:38:00 مساعدة (4)
عرض
أجابات (5)

xboxice Thanksa lot for this details write up just what i was looking for :)

activgsm 20/07/2022
I myself did over 1400 km on Boyueda and 1000 km on Laotian Ti30 - in both cases on factory square wave controllers - 45A JunLi in Boyueda and 37A JinPin in Laotie Ti30, respectively. In short, you should not use square wave controllers as we have in these devices at this power. I did a controller swap on my Laotian Ti30. The difference is colossal. No more jerking, switching 5 gears, etc. In standard controllers, the throttle response is based on the deflection angle (except for a huge dead scale) is as if assigned to a specific rotational speed of the engines, so with a small jump, a slight movement in a higher gear causes a mega jerk because the wheels want to change quickly speed. You know what I'm talking about. In sinusoidal controllers, the throttle acts as a gas pedal in the car, depending on the deflection, it doses the right amount of energy. As a result, it appears to be very flexible in all speed ranges. Of course, if we press harder, it will tear you forward. The power feels bigger from the bottom, the tires are literally screeching on the asphalt. I know that the energy losses in these controllers are smaller so we will gain on the range. The motors run very quietly. Acceleration is probably even greater than the standard ones. I saw the maximum speed of 85 km / h, so the same. But the driving experience is totally different. I am delighted :) Minuses? Minimal perceptible lag on the throttle response, but probably the same as in Boyueda. This was not in Laotie Ti30. Less high speed regenerative braking force than Ti30 (same as Boyueda). The ECO mode was better for me in the Ti30, but maybe I got used to it. Besides, the same pluses, I feel like I have new, completely different equipment. I recommend - now driving is pure pleasure, really ... ECO 27km / h, 1GEAR 35km / h, 2GEAR 55km / h, 3GEAR 85km / h
22
تعليقات (12)