كل الرسائل

سؤال: What is required to run 4S?

السؤال بواسطة Azzam على 2017-11-23 12:09:52

--oz-- As a minimum, 4S is highly recommended unless your a beginner pilot. After a friend has success with 6S, he is now going for 8S.Use a larger spar.

2020-11-29 09:08:49 مساعدة (0)
عرض
أجابات (2)

سؤال: how can i use this as an Arm button?

السؤال بواسطة Emmanuel على 2019-05-09 02:57:48

--oz-- There is a special function called "sticky", look it up on otx university.

2020-03-19 11:09:33 مساعدة (0)
عرض
أجابات (2)

سؤال: Is it possible to get it into Mode 1 ?

السؤال بواسطة mbaui على 2019-11-16 10:51:49

--oz-- Its mode 1 or 2, simply open it up, and adjust the screw to switch modes. Dont listen to the other guy.

2019-12-01 04:47:50 مساعدة (0)
عرض
أجابات (3)

سؤال: What can be programmed on this ESC and how is it done ?

السؤال بواسطة gbdc85 على 2019-09-14 05:58:14

--oz-- Since I cant post links here, search BLHeli_s manual, all the settings are adjustable by Tx (kinda a pain, but no more a pain than any other esc Tx programming), or use a $2 arduino nano or use a flight controller (betaflight/etc).

2019-09-14 05:29:06 مساعدة (1)
عرض
أجابات (1)

boblocke AllI had to do was wrap the plastic cover around the receiver and use it as a conventional 6 channel receiver . I did not use the 16 channel S port.

2019-07-29 07:41:28 مساعدة (1)
عرض
أجابات (1)

سؤال: why doesnit need a driver

السؤال بواسطة louisvr45 على 2018-10-20 02:21:42

--oz-- LEDs need the current controlled, if you just use a power supply with variable voltage, the current changes a lot with very very little voltage change, also when the led heats up, the required voltage drops a little. This causes a problem because the current will rise. At least use a resistor or a current limited power supply

2019-02-07 01:45:48 مساعدة (1)
عرض
أجابات (4)