كل الرسائل

pksteffen Yes! Thank you. Pull out slightly the two black tabs at the bottom where the ribbon cable goes into the board. They will slide a small amount out towards the edge of the board. This allows you to insert the ribbon cable into the slot and then push the two tabs and bottom piece back in to secure the cable to the board!

2019-08-08 04:04:35 مساعدة (0)
عرض
أجابات (1)

aerophoto Have you a picture helping to put the display connector on the right position to be able to start the receiver ? Thanks.

arturasraila 22/07/2018
9
تعليقات (2)

سؤال: STL technology

السؤال بواسطة aerophoto على 2018-01-02 01:58:15

Imbueeeam I don't know

2018-01-11 01:11:26 مساعدة (0)
عرض
أجابات (1)