كل الرسائل

Lucifer Buy one and measure it. If you can't afford to buy one to find out then you can't afford to start a business.

2023-03-03 10:06:45 مساعدة (0)
عرض
أجابات (1)

سؤال: 災害の時、自宅用、酸素の機械に対応できますか?

السؤال بواسطة BG463413162 على 2022-04-10 06:34:15

Lucifer No way. You need a Victron inverter if you want reliability.

2023-02-02 03:26:23 مساعدة (0)
عرض
أجابات (1)

سؤال: Quisiera saber O q m expliquen q es envió desde CN?

السؤال بواسطة BG523754224 على 2020-04-27 04:21:24

Lucifer Sent from CN means it's sent directly from the Chinese manufacturer.

2022-11-17 12:42:14 مساعدة (0)
عرض
أجابات (2)

سؤال: Can the output power be turned down?

السؤال بواسطة Lucifer على 2022-10-03 02:02:36

chinatronic I did not find an option that would allow to throttle the performance. However, the performance of these devices is usually stated much too high. An example is a device that is advertised with 8 watts Effectively, 3 possible transmitters frequency ranges 5+2+1 = 8 watts were added together

2022-10-23 03:11:33 مساعدة (1)
عرض
أجابات (1)

سؤال: it's written that it can go 100km/h in the description, how can you unlock that ?

السؤال بواسطة BG453217153 على 2022-08-29 10:17:05

Lucifer Top speed is limited by voltage. 48v battery is about 40-50kph. 60v battery is about 50-60kph. 72v battery is about 70-80. 84v battery is about 80-100kph. If the controller can't handle more than 60v then you're limited to about 60kph.

2022-09-07 07:37:10 مساعدة (0)
عرض
أجابات (2)

سؤال: CAN IT FIT FOR DATSUN GO PLUS 2018 MODEL

السؤال بواسطة Julian على 2018-09-28 03:56:12

BG453716393 It would fit all 12v vehicles.

2022-04-23 09:53:12 مساعدة (0)
عرض
أجابات (1)

BG453716393 Both will accelerate at roughly the same rate but the 48v will have a higher maximum speed. But this is also dependent on the batteries being able to supply enough amps.

2021-12-07 01:59:13 مساعدة (0)
عرض
أجابات (4)

BG453716393 You shouldn't have to change any capacitors, a car battery should provide enough current for 0.2mm. Just keep the battery cables short and use thick cables like jumper leads to connect to the battery. The 8mm width changes nothing - they can be 800mm and it'll still work the same. This is a spot welder so it welds a small dot where you hold the two probes against the nickel strips.

2021-10-09 04:56:21 مساعدة (1)
عرض
أجابات (1)