FondofBlondes
- محتوياتي
- كل الرسائل
- استعراضات
- تعليقات
- أجابات
- الأسئلة
أجابات
سؤال: How can this unit support 24Vdc when the smart relay from Wangll is marked 14Vdc?
السؤال بواسطة BG171536131 على 2022-02-01 17:10:18
سؤال: what is the diameter of the marking end of the pencil, not the refill’s.
السؤال بواسطة BG561844816 على 2023-11-25 14:34:39
FondofBlondes About 5.8 mm, so the hole of your guide or ruler needs to be at least 6 mm in diameter. The length of the tip is 40 mm, excluding the length of the protruding lead.
مساعدة (0)
سؤال: Can display be turned off ? Thanks.
السؤال بواسطة oz_pekeren على 2021-05-19 21:35:12
FondofBlondes If you are asking if the display can be switched off and still measure AHr or WHr, the answer is no. You can add a separate switch to disconnect the power to the meter which will switch off the display but that kind of defeats the purpose of the unit.
مساعدة (0)
سؤال: is this available in Metric size
السؤال بواسطة Antgeebee على 2020-06-28 05:07:03
FondofBlondes This set is not available in Metric size. You can get other Step Drill Bit Sets in Metric size. I will need to look elsewhere like Wish or AliExpress.
مساعدة (0)
سؤال: battery use 3 volt
السؤال بواسطة BG656184317 على 2023-08-17 10:31:46
FondofBlondes 1 X AAA 1.5V
مساعدة (0)
سؤال: What is the max diameter ?
السؤال بواسطة BG371010112 على 2021-05-23 01:16:24
FondofBlondes Already stated in description - from 0.5 to 4 mm square. Although I personally would not run anything more than 20A through that connector. A 4 mm square can handle 60A at 230V.
مساعدة (0)
FondofBlondes I measured 26 mA and I am sure most of it is to power the display.
مساعدة (0)
سؤال: What is the 2 pin connector on the bottom edge? Right below the "KWS-DC200"?
السؤال بواسطة Don على 2020-12-31 13:43:11
FondofBlondes To measure temperature with the included sensor.
مساعدة (0)
FondofBlondes The relay is rated at 14V and 20A DC, so if you double the voltage then halve the current and you should be fine.
مساعدة (0)