الشحن الى United Kingdom , USD
أعلى مراجعة إيجابية لـ %s على Banggood, تسوق أفضل %s بأقل سعر على Banggood. تصفح المراجعات الإيجابية الأكثر إفادة لـ %s قبل الشراء., ألعاب أرسي ، رياضة ممتعة ، أزياء ، إلكترونيات شعبية
tubby 21/09/2016
I've built and flown all of the Black Flyers: V1, V1.1 and V2. The V1 Is an excellent flyer, but the packaging means that some of the carbon can be broken in the post. The V1.1 and the V2 have improved packaging and a better wing fixing. The V1.1 is very similar to the V1 buthas an increased wing chord giving more wing area. Getting to the V2, it goes together well but, like the V1.1 it has a flat plate wing(s) which require great care in covering to avoid warping. It also means that the lack of wing section combined with the all flying tailplane means that the elevator is very sensitive and trim is critical. Both the V1.1 and V2 have a tendency to 'tuck' and dive into the ground. I feel that this is a design fault and they should have retained the cambered wing. On a value for money basis, you can't beat any of them. Weights with battery: V1 13.5 gm, V1.1 18 gm, V2 18 gm. All covered with tissue, not the supplied film.
45
تعليقات (5)
عرض
  • Do you have any advice on gluing tissue or the supplied film to the carbon-rod frames?

    رد 26/01/2017
  • mtrappett Did you have any issues with the tissue distorting the carbon fiber frame of the flying surfaces when it was shrunk? Did you use cellulose dope to shrink the tissue, or just leave it untouched? I have the same problem seeing the model with the transparent film, so I am going to use red colored tissue.

    رد 14/04/2017
  • BG481115191 Hi, where can i buy a kit with all parts included, like remote, battery, servo, receiver, etc?

    رد 21/01/2024
  • BG481115191 Hi, where can I buy a full kit with all parts like remote, servo, battery and receiver?

    رد 21/01/2024
  • BG521732473 No

    رد 15/04/2026
قياس مدى الرضا

حمل التطبيق للحصول على كوبون خصم بقيمة 10% حصرياً