فكوك خارجية من سانو لـ 3 مخرطة فكية ظرف K11-80 80 مللي متر ذاتي التمركز ظرف الفك
تمت ترجمة جزء من المراجعة تلقائيًا.
If you have EINHELL BT-ML300 it will work well. Check the numbering when mounting.
К патрону на 80 мм подходят идеально. Номер у всех кулачков одинаковый. Прилегание кулачков плотное но растачивать все равно прийдется.
وقد وصلت الشحنة الأصلية لسوء الحظ من فرنسا حيث اشتكت على الفور: فقد كانت إسبانياجوي رقم 3 مزدوجة، وكان الرقم 1 مفقوداً بالنسبة لها. بعد بعض الرسائل الألكترونية تم تسليم بديل لي. إنها فك صلب، والتي يجب أن تؤخذ في الحسبان عند استخدامها. إنهم يركضون بشكل مثالي و بدون لعب يستخدم في 300 الف فك واحد مع بطانة 80.
These fitted my 8 year old 80mm 3 jaw chuck, on an Axminster / Sieg C2 lathe. The chuck bears the name 'Tian Pai'.on a sticker. I obtained the lathe second hand with no outside jaws for the chuck. The run out using a 12 mm drill is acceptable (without any tweaking) at 2.5 thousandths inch, I suspect de-burring the sharp edges on the new jaws, and bumping the chuck run out could be used to reduce the over all runout. Very pleased with my decision to take the risk much cheaper than a new chuck. I can't guarantee that they will fit your chuck, check the measurements given carefully against you own inside chuck jaws as I did.
في التسليمِ الأولِ لسوء الحظ 2x مشبك فكّ رقم 1 سَلمَ، لذا غير قابل للاستخدام. الفك المشبك نفسه فك صلب ونظيف.
شكراً لك، فهمت. الجودة منخفضة، لكن الخرطوشة نهضت بشكل طبيعي. تم شراؤها للنشر والتجريب، لذا راضٍ بشكل عام.
Perfetto!
Precies de juiste maat buitenbekken voor een ander merk klauwplaat. Ik ben helemaal blij.
Tovar došil v poriadku
Exactly as discribed.Fits perfect on my mini lathe.A sale well done.Thank you.