الشحن الى United Kingdom , USD
أعلى مراجعة إيجابية لـ %s على Banggood, تسوق أفضل %s بأقل سعر على Banggood. تصفح المراجعات الإيجابية الأكثر إفادة لـ %s قبل الشراء., ألعاب أرسي ، رياضة ممتعة ، أزياء ، إلكترونيات شعبية
mike 02/12/2020
My ZX7-200 works well enough and is a good value if you require an occasional welder for light-medium work. 3mm rods work well enough - My ZX7 cannot push a 5mm rod, not close. So, I estimate max amperage at 130-160A. You can see some fairly heavy material I welded in the photos. The welds have held together. (And, note: I am not in any way a professional welder- hobbyist only) I had a significant amount of weld spatter and sticky starts mostly and, the job got done anyway, which I might have expected for such an inexpensive welder. Or, maybe it was just bad rods. I made 2 alterations which I believe increased value as in: 1) Fitted a longer and heavier power cord - the original seemed too light, possibly 14 gauge which seems a bit unsafe. 2) Replaced the impish aluminium bus bar inside with a heavier copper bus bar. If you do the bar mod, be sure to use some anti-oxidation paste on screws and connections. Overall, I am pleased with my purchase even though there are some shortcomings. So pleased, I ordered a second one!
39
تعليقات (4)
عرض
  • BG168384275 https://banggood.app.link/SNkLCK3G4eb

    رد 31/03/2021
  • Jerry M. Honeycutt Jr. hi, bevel your material and slow down! you arent getting enough penetration most of your weld is on the surface, needs to be in the material not on it. pre-heat metal with propane torch, bevel and showing down with a supportd wrist will improve your welds a lot.

    رد 21/04/2021
  • BG513421110 @Jerry M. 👍 Sehr gute Antwort!

    رد 13/05/2021
  • Rod Nadeau HiMike I would to know what size breaker in your breaker panel did you need to use to furnish the welder.I have a 6/3 wire going to the outlet or is it to much,or do I need to only use a 12/2 wire.Thank you

    رد 18/06/2021
قياس مدى الرضا

حمل التطبيق للحصول على كوبون خصم بقيمة 10% حصرياً