الشحن الى United Kingdom , USD
أعلى مراجعة إيجابية لـ %s على Banggood, تسوق أفضل %s بأقل سعر على Banggood. تصفح المراجعات الإيجابية الأكثر إفادة لـ %s قبل الشراء., ألعاب أرسي ، رياضة ممتعة ، أزياء ، إلكترونيات شعبية
greg 06/03/2021
ive installed this on my direct drive modded ender 3 v2, mounting holes match the Ender 3 perfecly. it is about 5mm shorter in height than the stock Ender 3 hot end which meant I had to swap out my custom part cooling duct back to the stock part cooling duct. This came with a black silicone sock for the hot end but does not come with a nozzle, ptfe tube, heater or thermo. so you will need to swap over these parts. dont forget to re-level your bed after as this will sit higher than the stock hot end. it came assembled but found it easier to dismantle and install the body first fit the heater element and thermo then reassemble. pick tightened all together ran a heat cycle then re-tightened all screws and the nozzle before feeding filement. so far ran some PETG at 280 degs and getting some great results. all in all was able to fit this in about 20 minutes. Great bit of kit, very happy.
0
تعليقات
عرض
قياس مدى الرضا

حمل التطبيق للحصول على كوبون خصم بقيمة 10% حصرياً