تمت ترجمة جزء من المراجعة تلقائيًا.
منتج رائع
I was able to mount this directly to my Ender 3 V2 stock mount using 2X 25MM M3 screws by tapping then drilling out paths in the top fin of the heat sync. I did this by removing the stock hot end and using it to center the screws and using spare M3 screws to tap the Heat sync. I then drilled out the paths using the tap as a guide. I was also able to transfer the Ender hot end and heat break as well. I didn't use any of the electronics. You will need to print a custom fan shroud. As for the parts, nothing premium here. All basic cheap parts but made with precision. I cant speak for the electronics. Side note, There is a custom PTFE insert called a throat I think. It would be great if Banggood sold spares. It is a 7mm to 4mm OD reducer that funnels the filaments into the hot end. The 2 in 1 out version also has one, but it's shorter.
جاءَ مثاليَ
وصل هذا البند بأمان وفي الوقت المحدد ، تضررت التعبئة والتغليف قليلا ولكن لم يتلف هوتند. الجودة جيدة على الرغم من أنني لم أقم بتثبيت الوحدة بعد ولكن لا نتوقع أي مشاكل.
لم يحاول بعد ولكن سوف تحديث عندما كنت قد استخدمته ولكن نوعية الحكمة انها جيدة حقا، أفضل مما اعتقدت أن نكون صادقين. جرب البائع ...
يوصى بشدة
3rd class service by banggood . after 10 time conntrack 100 days to resive
لا أستطيع الانتظار لاستخدام بلدي 3 في طارد واحد 😀😃
المثالية لا يمكن أن تراهن على هذا
ممتاز