3 قطع 1M PTFE أنبوب بودين لطابعة Reprap 3D 1.75mm فيلامنت
تمت ترجمة جزء من المراجعة تلقائيًا.
Parfait pour déporter le moteur d'un extrudeur.
correspond au déscriptif
the PTFE tube itself is fine, comes with 2 push fit ends aprox m10 thread. so glad I also ordered some m5 push ends. where i was disappointed was the packing, it comes coiled to a diameter of aprox 100mm which is bad enough, but then the ends were wrapped through the coil , causing the whole length to take a spiral form, the worst of which suspending with a weight on the end for a day or 2 managed to remove. so usable but a bit kinky
حسب المواصفات
جودة ممتازة، لقد تلقيت ما توقعته، ومع ذلك أعتقد أن لشخص مثلي الذي لديه طابعتين فقط، هو الكثير من قطع الغيار، ولكنه ليس كثيرا. ممتاز، إنّه يُعتبر أنّه يُحظر على شخصٍ ما أن يُدفع له منفردين، لكنّه لا يُوجد شيء.
فقط لفترة طويلة لكن لا بأس
very Good
تسليم سريع
كما هو موصوف...
حصلت عليه، ولكن لا تستخدمه بعد.