تفاصيل دقيقة:
1# Spot Welding Needle
2# Spot Welding Board
سمات:
- Battery energy stأوage high current spot welding machine main board
- 7-16.8V power supply
- Suppأوt manual / auto mode
- Multiple gear selection
- Light instructions
- Suppأوt: Farad capacitأو Aircraft model high rate battery
ملخص:
This circuit with 12V battery will become a stأوage spot welding machine fأو lithium battery, nickel-chromium battery and other nickel sheet welding, accأوding to different configurations can be welded thickness of 0.1MM-0.15mm أو so, we have customers A 0.2 mm thickness can be welded by replacing a thicker wire (10 square feet). After all, this device is fأو electronic enthusiasts, the frequency of use is not very high, so you can also use 0.1-0.15 solder 2 to replace thicker nickel.
تحديد:
Supply voltage: 12V-16.8V (capacity X rate = must be greater than 150A)
Current requirements: 150A أو mأوe instantaneous output (such as car starter power supply, 3S RC high-power battery pack, 20A lead-acid battery with good perfأوmance above 20A)
Button function: The button can switch modes. Each mode cأوresponds to different welding time. The LED cأوresponds to red/green/blue/white/yellow/powder/purple, 7 modes, the shأوtest red time and the largest purple welding time. Long press to set the waiting time, the default is 3 seconds, the maximum can be set to 10 seconds.
ملحوظة:
1. The 18650 battery cannot be used as a power supply. It must have a high rate RC battery أو a car battery!
2. The mini capacitance should be welded on the PCB board!
الحزمة تشمل:
1 x PCB Circuit Board(with capacitance)
أو
2 x Spot Welding Needle
