الشحن الى United Kingdom , USD
أعلى مراجعة إيجابية لـ %s على Banggood, تسوق أفضل %s بأقل سعر على Banggood. تصفح المراجعات الإيجابية الأكثر إفادة لـ %s قبل الشراء., ألعاب أرسي ، رياضة ممتعة ، أزياء ، إلكترونيات شعبية
blitzen 04/10/2019
The TeenyF4 Pro Flytower comes with 2M standoffs, screws and nuts. I also used tiny rubber rings (and longer screws) to soft mount the flytower onto a SPC 95EP frame. Soldering the motors to the 4 in 1 ESC was easy. The 5A ESC can handle motors as large as 1102. I'm using smaller Happymodel 0802 19000KV motors (1S). A battery connector is not included with the flytower. I chose a JST-PH2 battery connector and 3.8V 450 mAh LiPos. The solder pads on the flight control board are very small and require a steady hand. A small tipped soldering iron is helpful. I've attached a 25mw AIO Cam/VTX w/ OSD and a small FrSky D8 receiver. After binding the receiver to the TX and configuring basic settings in Betaflight, the quadcopter flew surprisingly well. Updating the firmware and configuring Betaflight (PIDs and rates) is the next step.The green propellers shown in the picture have been discontinued. Red & black Eachine 3 blade propellers are current. All of the parts mentioned here are available from Banggood. I would recommend the TeenyF4 Pro to anyone interested in building a compact lightweight micro.
0
تعليقات
عرض
قياس مدى الرضا

حمل التطبيق للحصول على كوبون خصم بقيمة 10% حصرياً